Exmark Lazer HP Manuel d'utilisateur télécharger pdf (Page 32)

- 27 -

4.4.2 Loading a Unit: Use extreme caution when loading units on trailers or trucks.

One full width ramp that is wide enough to extend beyond the rear tires is

recommended instead of individual ramps for each side of the unit. The lower

rear section of the tractor frame extends back between the rear wheels and

serves as a stop for tipping backward. Having a full width ramp provides a

surface for the frame members to contact if the unit starts to tip backward. If it is

not possible to use one full width ramp, use enough individual ramps to simulate

a full width continuous ramp.

Ramp should be long enough so that the angles between the ramp and the

ground and the ramp and the trailer or truck do not exceed 15°. A steeper angle

may cause mower deck components to get caught as the unit moves from ramp

to trailer or truck. Steeper angles may also cause the unit to tip backward. If

loading on or near a slope, position the trailer or truck so it is on the down side of

the slope and the ramp extends up the slope. This will minimize the ramp angle.

The trailer or truck should be as level as possible.

DO NOT attempt to turn the unit while on the ramp, you may lose control and

drive off the side.

Avoid sudden acceleration when driving up a ramp and sudden deceleration

when backing down a ramp. Both maneuvers can cause the unit to tip backward.

5. MAINTENANCE & ADJUSTMENTS

5.1 PERIODIC MAINTENANCE

5.1.1 Check engine oil level:

Service Interval: Daily

a) Make sure engine is stopped and on a level surface.

b) For Kawasaki Liquid-Cooled units – tilt seat up and tilt hood forward to gain

access to the engine area.

c) Check with engine cold.

d) Clean area around dipstick. Remove dipstick and wipe oil off. Reinsert the

dipstick and push it all the way down into the tube. Remove the dipstick

and read the oil level.

e) If the oil level is low, wipe off the area around the oil fill cap, remove cap

and fill to the “F” mark on the dipstick. Use oil as specified in Engine

Owner’s Manual. DO NOT overfill.

IMPORTANT: DO NOT operate the engine with the oil level below the “L”

mark on the dipstick, or over the “F” mark.

5.1.2 Check engine coolant level (Kawasaki Liquid-cooled units only)

Service Interval: Daily

a) Make sure engine is stopped and machine is positioned on a level surface.

b) Tilt seat up and tilt hood forward to gain access to the cooling area.

c) Check with engine cold.

d) View coolant level in overflow bottle on the left side of the engine. Coolant

level should be at the indicator line on the overflow bottle.

e) If the coolant level is low, remove the cap to the overflow bottle and fill to

the indicator line. Use coolant specified in Section 2.5.2.

NOTE: Kawasaki 23 & 27 HP Liquid-cooled units should only be filled with Dex-

by its orange color.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 69 70

Commentaires sur ces manuels

Pas de commentaire

Exmark Lazer HP Manuel d'utilisateur Page 32

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel de jardinage Exmark Lazer HP