Exmark Lazer HP Manuel d'utilisateur télécharger pdf (Page 25)

- 20 -

3.8 INSTALL MOTION CONTROL LEVERS.

3.8.1 Loosen and remove the two (2) 3/8” x 1” bolts and spring disc washers which attach

the motion control levers to the control arm shafts for shipping and the

two (2) 3/8” x 1” bolts and spring disc washers which are screwed into the control

arm shafts.

a) Install the left motion control lever onto the control arm shaft (See Fig.4) on the

left side of the console. Place the lever (with the mounting plate towards the

rear) on the outside of the control arm shaft and secure with the bolts and

washers. Position the lever so the bolts are in the center of the slots on the

lever mounting plate and tighten until snug. Repeat on opposite side of unit.

NOTE: There are two lever height options available on newer units. Place the

levers in the top two holes to increase height of the levers, or in the bottom two

holes to decrease the height of the levers.

If the levers do not align with each other, when in the neutral position, (See

Fig. 5) loosen the hardware and make the appropriate adjustment by sliding/tilting

the lever(s) forward or backward until properly aligned and tighten hardware.

FIG. 4 FIG. 5

CONTROL ARM SHAFT LEVER ALIGNMENT

b) If the ends of the levers hit against each other, while in the drive position

(levers rotated in as far as possible), make adjustments by moving the levers

outwards to the neutral lock position and carefully bend them outward. Move

them back to the drive position and check for clearance, repeat if necessary.

3.9 POSITION DISCHARGE CHUTE.

3.9.1 Loosen two (2) 5/16” nyloc nuts attaching discharge chute. Lower the discharge

chute into position. Retighten nyloc nuts until chute is snug but can pivot freely.

3.10 SERVICE ENGINE.

Engine is shipped with oil; check oil level and if necessary fill to the appropriate

level with SAE 10W-30 or 10W-40, AP1 service class SF or SG for operating in

temperatures above 0° F (-18° C). See Engine Operator's Manual.

3.11 SERVICE ENGINE COOLANT (Kawasaki Liquid-cooled Units Only)

Machine is shipped filled with engine coolant.

LEVERS IN

ALIGNMENT

MOUNT PLATE TO

THE REAR & OUTSIDE

OF ARM SHAFT

MOTION

CONTROL

LEVER

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 69 70

Pas de commentaire

Exmark Lazer HP Manuel d'utilisateur Page 25