Exmark Lazer HP Manuel d'utilisateur télécharger pdf (Page 27)

- 22 -

When levers are centered in the T-slot the drive system is in the neutral position.

With levers moved out in the T-slot the drive system is in the neutral lock

position (See Fig. 6).

FIG. 6

MOTION CONTROL POSITIONS

By moving both levers an equal amount forward or back from the neutral position

the machine can be caused to move forward or backward in a straight line.

Movement of the left lever forward will cause the left drive wheel to rotate in a

forward direction. Movement of the right lever forward will cause the right

drive wheel to rotate in a forward direction. To stop forward travel, pull the

levers back to the neutral position.

To turn left while moving forward, move the left lever back toward neutral to

slow the left drive wheel.

To turn right while moving forward, move the right lever back toward neutral to

slow the right drive wheel.

To make a zero turn to the left, pull the left lever back beyond neutral while

holding the right lever slightly ahead of neutral.

To make a zero turn to the right, pull the right lever back beyond neutral while

holding the left lever slightly ahead of neutral.

Pulling the levers back from the neutral position will cause the respective drive

wheels to rotate in a reverse direction (spring tension can be felt when moving

into reverse from neutral).

To turn to the left while backing, move the left lever forward toward neutral. To

turn to the right while backing, move the right lever forward toward neutral.

CAUTION

POTENTIAL HAZARD

♦ Machine can spin very rapidly by positioning one lever

too much ahead of the other.

WHAT CAN HAPPEN

♦ Operator may lose control of the machine, which may

cause damage to the machine or injury.

HOW TO AVOID THE HAZARD

♦ Use caution when making turns.

♦ Slow the machine down before making sharp turns.

4.1.3 Blade Engagement Switch: Located just left of center on the console (left side of

ignition switch). Switch must be pulled out to the “ROTATE” position to engage

the blades. Switch is pushed in to the “STOP” position to stop the blades.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 69 70

Pas de commentaire

Exmark Lazer HP Manuel d'utilisateur Page 27